The tire swings are large and usually used by two or three children at the same time, they can also help children exercise several different muscle groups in the body, improve coordination and motor skills, and form strong muscles. In addition to purchasing, we can also DIY the tire swing by ourselves, the specific steps are as follows.
Pick the correct tree
Chances are, if you’re looking into how to make a DIY tire swing, you already have a tree in mind for mounting it. Just make sure that it’s large, healthy, and the branch that will hold the tire swing is at least 8 inches thick. If a tree shows signs of decay or has cracks or dead branches, it’s not suitable for a tire swing.
It is neccessary to make sure there’s enough clearance between where the tire hangs and the trunk of the tree as well as the ground. And remove large rocks or other tripping hazards from the area beneath the swing.
Find the right size tire
Any standard-size passenger car rubber tire will work for a swing, though you could use a smaller or larger tire as long as you factor the weight into your specific project. If you find a used tire, be sure it has some tread left to prevent any wires from popping through the surface and scratching or poking swing users.
Clean the tire
Give the tire a thorough cleaning with a pressure washer. If you don’t have the right tool, take the tire to the car wash to clean it with one of the high-pressure hoses on the premises.
Drill drainage holes in the tire
When you’re ready—that is, when you’re satisfied with the cleanliness of the tire—drill holes in the bottom of the tire to prevent water from pooling when it rains. You don’t want mosquitoes to get wind of any standing water! On that note, you’ll also want to check for bees, wasps, and other insect pests each time you or your kids use the tire swing.
Determine the maximum weight your tire swing will hold. That includes the weight of kids (or adults) that will use it as well as the weight of the tire you choose. Then select a heavy-duty braided exterior rope that is rated for three times that weight.
Tie a double bowline knot
Cut a section of rope to the desired length plus a little bit extra for tying a couple of knots. If needed, melt the ends to keep the rope from fraying. Tie a double bowline knot on one end of the rope, making sure to leave a little slack in the loop portion of the knot.
Hang your rope
Toss the knot end of the rope over the tree branch. If you need a little help, place a softball in a sock and tie the sock to the knot end of the rope; then toss the ball over the branch. Thread the opposite end of the rope through the loop of the bowline knot and pull it tight. The knot will travel upwards until it finally reaches the branch.
Suspend the tire
Tie another double bowline knot around the top of the tire, tightening it so the tire hangs at the desired height off of the ground.
Test the tire swing
Have the heaviest member of your family test the tire swing to ensure its strength.
Because just through some simple operations and devices, the children's tire swing made by yourself may not be able to guarantee its stability. The tire swing designed by BIG ELEPHANT can be easily installed on most residential wooden swings. The closed tire is made of rotomolded plastic and will not allow water or debris to accumulate inside the tire. It is recommended for children aged 3 to 11 years. If you have a need for this, you are welcome to search for related products on the website and contact us.
As a professional manufacturer of outdoor fitness equipment for children, we are committed to providing every customer with high-quality and safe products. We put the needs of customers in the first place, continuously optimize and adjust the design plan, can provide customers with thoughtful one-stop service and develop effective solutions. We have an experienced production team that can guarantee the quality of our products. If you want to buy our children's swing, please contact us immediately!